Restoration and Replacement of Ceramic Tiles

The appealing elements of the plumbing systems – towel bars, soap dishes, porcelain exteriors of the fixtures and ceramic tiles – necessitate reparations just like the pipes. Polished chrome dulls with coatings of mineral sediments; porcelain or ceramic enamel will certainly be discolored by the rust pigments – normally because of the leaking or trickling faucet that should have been fixed – or because of the chemicals present in water. The hair dryer has slipped from your hand and you now have a fragmented bathtub. There are times wherein the ceramic tiles will loosen and eventually fall from the walls due to improper installation or aggregating effects of humidity and time.

 

 

One of the most usual reparation in the bathroom is sealing of breaks in the junction between the wall and the bathtub – is a dull and boring chore because of the alterations in the heaviness of the bathtub since it is jam-packed and emptied over and over again.

 

It is important that you take necessary precautions in all things you do. As a result, wearing of goggles is advisable if you have shattered tiles, be sure to wear gloves if you are going to work with wet grout or powerful cleansers. And if you are surrounded with breakable and delicate surfaces in your bathroom, be sure to handle heavy equipment with great care because a single mistake can certainly cost reparation of the entire structure.

 

Ceramic Tile Replacement

 

1. Remove the tile. Make use of a cold chisel and hammer and be sure to wear googles. Break the center portion of the tile, then remove the pieces. If the tile is still in a complete piece and can still be reused, remove the cement on its back. Be sure to eradicate all uneven and loose cement in the tile bed.

 

2. Reorganizing the tiles. Smear a tile adhesive at the back portion of the tile by means of holding it on its edges; place it in its designated area so that it is uniform with its nearby tiles. Make sure to leave the tiles overnight in order for the glue to be completely dry.

 

3. Placing the grout. Utilize tile grouts that are already mix to fill and stick the joint areas in the new tiles. Initially, you should press the grout into the intersections with your fingertips, then obtain a window squeegee or damp cloth to eliminate the extra grout from tiles.